Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Before
After
Before
After
Before
AfterFast, Reliable Driveway & Pavers Across Austin
Driveway and paver work in Austin splits along the Balcones Escarpment: west of I-35 you’re often cutting through Edwards limestone to set a base, while east Austin’s black Vertisol clay demands deep, stabilized subgrades before a single paver or yard of concrete goes down. That’s why the price range on this page runs $3,500 to $18,000, and why the spec you choose on day one decides whether your surface survives the next drought cycle. Our Driveway & Pavers team works both sides of that fault line every week, and we put the written price in your hand before any equipment shows up. Call (470) 298-9650 and we’ll tell you which side of the escarpment you’re on and what it means for your project.
Why Rowan Construction Group Is Austin’s Preferred Driveway & Pavers Company
Since 2007, Rowan Construction Group has completed over 4,000 projects under one rule: the price is written before the work starts. Not a verbal range, not a “we’ll see what we find.” A flat number with a written scope and a written warranty, signed before the first cut. In Austin, where a driveway quote can swing by thousands depending on whether the subgrade is limestone shelf or expansive clay, that discipline matters.
Our Austin customers deal with two geologies in one city, and our crews know both. We’ve pulled paver jobs apart in Travis Heights, rebuilt concrete drives in Brentwood, and trenched utilities in Allandale where the rock saw was on site by 7 a.m. because we planned for it. Every estimate starts with a site visit, not a photo, and every visit ends with a documented photo record of what we found. Call (470) 298-9650 and we’ll schedule that visit at no charge.
Our Driveway & Pavers Services in Austin
Paver Driveways
A paver driveway in Austin runs $7,000 to $18,000, and the geology under the project is the single biggest cost driver. West of I-35, where Edwards limestone sits close to grade, our crews often saw-cut rock ledges and import crushed aggregate to build a level base. East of I-35, on expansive black clay, we specify geogrid reinforcement and deeper compaction so the pavers don’t heave apart when the soil cycles from bone-dry to saturated. We use Belgard and Techo-Bloc pavers because they hold dimensional tolerance through Austin’s temperature swings, and we seal the joints with polymeric sand on every job.
Concrete Driveways & Concrete Work
Poured concrete driveways in Austin typically land between $4,500 and $12,000. The number changes based on access, slope, and whether we’re removing an existing slab or cutting into rock. East Austin’s clay soils shrink in summer drought and swell when the rains return, which means we cut expansion joints on tighter spacing than inland standards and often add a compacted, moisture-stable base layer. We use Sakrete and other specified mixes matched to the weather window, because a pour in a 105-degree Austin afternoon needs different set control than one in February.
Asphalt Driveways & Resurfacing
Asphalt paving in Austin runs $3,500 to $9,000 for a new residential drive, with resurfacing at the lower end of that range. Austin’s heat softens asphalt more than northern climates, so we specify a mix with higher aggregate density and recommend sealing on a two-year cycle to slow oxidation. Asphalt performs best on the deeper soils of east Austin and the flatter lots in Pflugerville, though a properly compacted stone base makes it viable across most of the metro.
Driveway Repair & Replacement
Replacement of a failing Austin driveway runs $5,000 to $14,000, depending on what the existing subgrade has done. We see two distinct failure patterns: west Austin slabs that crack where the concrete spans from shallow rock to deeper fill, and east Austin drives that heave vertically at the joint lines after the clay expands. We don’t patch over either without explaining what’s underneath. Call (470) 298-9650 and we’ll walk the site with you, then put the fix in writing.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterTrusted Brands We Service in Austin
We stock and install a tight list of brands that have proven themselves in Austin’s soil and sun: Sakrete for concrete and repair products, Belgard and Techo-Bloc for pavers and retaining wall systems, and a few others we trust enough to stand behind our 365-Day Done Right Promise. When we quote a paver driveway, the brand name and the specific product line go on the written scope, so you know exactly what’s being installed. If you want a different manufacturer, we’ll price it honestly against what we’d spec. But we won’t install a brand we can’t warranty in Austin’s clay.
Common Driveway & Pavers Problems We See in Austin Homes
- West Austin differential settlement: Paver jobs laid directly on scraped limestone develop localized dips where shallow rock outcrops create hard spots, and the transition zone to deeper soil cracks pavers within two seasons. We saw-cut the ledges and build a uniform aggregate base instead.
- East Austin slab heave: Concrete poured on compacted clay without proper expansion joints moves vertically an inch or more after a wet spell following a drought, then cracks diagonally across the slab. We cut joints closer and stabilize the subgrade before the pour.
- Efflorescence on sealed pavers: White chalky stains on brick paver driveways in Central Austin often trace to a sealed surface trapping moisture rising through an unvented concrete subbase. The salts in the clay deposit at the surface and stain the joint sand. We address drainage and ventilation, not just the stain.
- Edge restraint failure at the curb cut: On a Travis Heights replacement, we removed a 2012 brick paver job where the sand-set joints had opened to finger-width and the edge restraint had lifted 2 inches. The original installer had graded over two buried limestone ledges. We cut them out, rebuilt with a geogrid-reinforced section, and sealed the joints. Three drought-to-flood cycles later, nothing has moved.
Pricing for Driveway & Pavers in Austin, TX
Here is what we quote in writing, before any work begins. These are Austin-specific numbers, and they include the subgrade work that the cheap spec skips.
| Service | Austin Price Range |
|---|---|
| Paver Driveway Installation | $7,000-$18,000 |
| Concrete Driveway Installation | $4,500-$12,000 |
| Driveway Replacement | $5,000-$14,000 |
The gap between the low and high end of each range is geology and access, not margin. A paver drive on east Austin clay costs more on the base work; one on west Austin limestone costs more on rock removal. We write the number after we see the site, and that number is the number. Call (470) 298-9650 for a free written estimate, and if you have a competitor’s quote, bring it. We’ll review it line by line at no charge.
We Also Serve Cities Near Austin
Our crews work across the Austin metro, including Austin neighborhoods like Brentwood, Crestview, Allandale, and Travis Heights, plus Pflugerville, Cedar Park, Round Rock, and Leander. The geology shifts again once you’re north of the city, but the subgrade discipline stays the same. If you’re in any of these areas, call (470) 298-9650 and we’ll route the right crew to your site.
Serving Austin, TX - Our Local Coverage Area
We’re based in the Austin area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Driveway & Pavers in Austin
If your property sits west of I-35 on the Edwards Plateau limestone side, pavers are often the more forgiving choice because the segmented surface can absorb slight rock-related movement without cracking a monolithic slab, but the base prep is more expensive because we have to saw-cut or blast through shallow rock ledges. If you’re east of I-35 on expansive clay, concrete performs better only with deeper, stabilized subgrade and tighter joint spacing, and pavers need geogrid reinforcement to prevent heaving. Call (470) 298-9650 and we’ll tell you which side you’re on and price both options in writing.
Yes. Austin’s Heritage Tree ordinance protects any tree 19 inches or greater in diameter, requiring a city permit and mitigation payment for removal, and trees at 24 inches or more need City Council approval that is rarely granted. On infill lots in neighborhoods like Travis Heights or Crestview, that can force us to redesign a driveway footprint or shift a paver patio around a protected live oak, adding weeks and sometimes significant cost. We factor tree protection into the written estimate before any work starts, so call (470) 298-9650 and we’ll check your trees against the ordinance.
The black Vertisol clay under east Austin shrinks dramatically during summer drought, pulling the slab down and opening the joints, then swells when rains return and pushes upward. If the original pour didn’t include deeper compaction, a moisture-stable base layer, and tight joint spacing, the slab moves every season. We fix it by removing the failed slab, repairing the subgrade, and repouring with the right joint layout and base spec. Call (470) 298-9650 for an estimate on a proper rebuild.
On average, a paver driveway on west Austin limestone costs $3,000 to $5,000 more than the same footprint on east Austin clay, driven mostly by rock sawing and removal. The clay-side job costs more on base stabilization, but rock work is more expensive by the hour. A 600-square-foot paver driveway could run $12,000 on limestone and $9,000 on clay, all else equal. We’ll give you a precise number for your specific site. Call (470) 298-9650 for a free written estimate.
Those white stains are efflorescence, salt deposits from Austin’s clay soil that move upward through the paver base and crystallize on the surface when moisture evaporates. Sealed joints on an unvented concrete subbase trap that moisture and force it to the surface, where it stains the pavers and washes out the joint sand at the perimeter. The fix is drainage and ventilation, not just a surface sealer. Call (470) 298-9650 and we’ll diagnose what’s under your pavers.
Get Your Written Driveway & Pavers Estimate in Austin
If you’re in Austin, Pflugerville, Cedar Park, Round Rock, or Leander, call (470) 298-9650 and we’ll schedule a free site visit. We’ll check your subgrade, map your trees, and hand you a written price with a written scope, before any equipment leaves the yard. That’s Clause 1 of The Haven Standard, and it’s been the rule on every one of our 4,000-plus projects since 2007.
Written by Grant Rowan, Owner at Rowan Construction Group, serving Austin under The Haven Standard.
Driveway & Pavers in Nearby Areas
